ATERM WL54SC DRIVER

Operation is subject to the following two conditions: Using multiple SSIDs requires additional network scans and decreases battery lifetime. The tag has now been reset to factory settings. The scanning consumes a high amount of energy, and the more scanning is done the less battery life the tag has. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Press and hold the Menu button for 3 seconds. FCC ID of this device is:

Uploader: Magal
Date Added: 1 February 2010
File Size: 29.31 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83393
Price: Free* [*Free Regsitration Required]

TB user interface 1. It is not recommended to use the feature, if not required, due to higher power consumption. Use of the Tags not in compliance with their respective documentation, user ater, instructions, and any usage restrictions contained therein, including, but not limited to, the provisions relating to the environment and ranges where the tags must be used, or 4. Thus, do not take the TB tag next to permanent magnets.

Tags that have been altered, modified, repaired or tampered with by anyone other than Ekahau, 3. After successful activation, the tag MAC address appears on the atsrm window, showing Ok status.

Activating unnecessary channels will reduce the tag’s battery lifetime! Typ- ically these parameters are used to improve accuracy in very difficult conditions or in cases the tag otherwise would scan rarely.

  BROOKDALE G GRAPHICS CHIP ACCELERATED DRIVER

OneJP, Japanese Auctions! laptop

Sadly, I have no more PowerBooks to swap and test the card: High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.

Used to improve the accuracy in difficult conditions and for rarely scanning applications. Failed to scan or send results – red. Initial Ategm of the Tag 2 Initial Activation of the Tag When the tag is delivered it does not have any of the necessary configuration settings. I guess I’ll have to do the swapping with my PowerMac G5. Ekahau reserves the right to revise this document or withdraw it at any time without prior notice.

After that, follow the following Activator configuration procedure: Home Forums Library Links Bounties. This manual and the Ekahau hardware described in it may not be copied. Initial Activation of the Tag 12 The Activation window shows all the settings on the upper side of the window. The firmware needs first to be uploaded into EPE, this is done lw54sc configs page.

Install wl45sc supported Wi-Fi adapter using the driver provided by Atemr. The contents of this document are provided “as is.

category result

However, there is no guarantee that interference will not occur in a particular installation. FCC ID of this device is: Can you please link to one of these? Tip After you have finished the activation, you can save the configuration for future use from the file menu. Green indicates successful activation. The Ekahau supported adapters are Chapter 4.

  MEDICUS DUAL-HINGED OVERSIZED DRIVER DOWNLOAD

After completing the “Positioning engine settings”, the status ateerm should show “Engine Ok”. Configuration After Initial Activation 3 Configuration After Initial Activation The tag can be adjusted for each application and network settings by adjusting a set of parameters. Its moving parts can be damaged. My use of the wireless hardware is not that regular as I know the latching to the signal available is not that impressive when compared to the Apple hardware which wk54sc an ‘Interference Rubustness’ setting that seems to boost the incoming signal reception or at least make more of it than the MorphOS system seems to currently, sadly.

Blue button 3 Wp54sc 1. The new firmware needs to be first uploaded in the configs page A list of available firmware updates uploaded in EPE. Periodic or motion activ- ated scan. The list of the activated tags will appead on the area below. Recommendations for optimizing battery lifetime: