DRAFTMASTER SX DRIVER

If it does not have a paper cutter, use a sharp blade or another cutting device. When this process is complete, the plotter will display Cut page, rotate 90 degrees. Make sure the pen is in good operating condition and has a tip size of 0. This includes both the stripe and the white dots on either side. Raise the plotter’s carriage cover. How does HP install software and gather data?

Uploader: Mabei
Date Added: 25 August 2009
File Size: 49.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54650
Price: Free* [*Free Regsitration Required]

When cutting and reloading daftmaster media, place the cut edge along the left side of the platen. Load a sheet of E or D size polyester film in the plotter.

HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots

When the calibration procedure is complete, the message Calibration complete will display. Make sure the pen is operational. The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen. Raise the paper-loading lever.

Use a cloth dampened with water if this surface needs cleaning. If it does not have a paper cutter, use a sharp blade or another cutting device. Drafmtaster parts have been changed pinch wheels, for example.

  AMD CCC FAILED TO LOAD DETECTION DRIVER

The plotting environment differs considerably from the calibration environment at the factory 18 to 30 degrees C, level floor. Remove the media from the plotter. Then, check draftmasfer following and start over:.

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration | HP® Customer Support

When this process is complete, the plotter will display Cut page, rotate 90 degrees. Rotate the page 90 degrees clockwise and reload the media in the plotter. Turn the plotter off and then on again before plotting. Javascript is disabled in this browser. Additionally, verify that the white stripe on the platen is clean. The pen holder will move across the media several times, sensing the corners of the square just drawn.

The Virtual Agent is currently unavailable. Pull the paper-loading lever towards you to raise the pinch wheels. If it has a rollfeed plotter, use the paper cutter to cut off the bottom of the page, flush with the slot in the plotter’s platen. Calibrating makes the plotter’s drawing characteristics as accurate as possible.

See your browser’s documentation for specific instructions. This page requires Javascript. This includes both the stripe and the white dots on either side. If the calibration fails, the message Calibration failed will display. The pen holder will move across the platen.

  EPSON R280 CD PRINTER DRIVER

The cut edge of the media should be along the left side of the plotter. Pen 8 will then be retrieved from the pen holder and a square will be drawn. Load a black drafting pen in stall 8 of the pen carousel.

Europe, Middle East, Africa. When reloading polyester film, place the writing surface face up; make sure the left pinch wheel is correctly aligned with the left edge of the plotting media. Handle the film by the edges so as not to get fingerprints on it. How does HP install software and gather data? Turn the plotter off and then on again to clear the display. Make sure the pen is in good operating condition and has a tip size of 0.

Raise the plotter’s carriage cover.