LABVIEW STEPPER MOTOR DRIVER DOWNLOAD

I don’t really care what speed the motors run at or any of that, I just need a program that can run these stepper motors. Most Active Hardware Boards: Best regards, Jochen Klier National Instruments. Using the counters of a E- or M-Series board to control a stepper motor is not recommended, as this method doesn’t provide features that are typically required for a motion control application e. Hi Steve, What motion controller are you using?

Uploader: Yozshubei
Date Added: 15 October 2006
File Size: 69.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92664
Price: Free* [*Free Regsitration Required]

Controlling a Stepper Motor with LabVIEW – Discussion Forums – National Instruments

I shall really apprecaite that and will be highly obliged with you. I have a similar program to write in that it is also to use Peter’s board. Hi, I’m not sure whether this is the right place for asking this question or not and if not, then please guide me to the right place for asking step;er question.

I don’t really care what speed the motors run at or any of that, I just need a program that can run these stepper motors. Using the counters of a E- or M-Series board to control a stepper motor is not recommended, as this method doesn’t provide features that are typically required for a motion control application e. Message 7 of Basically, I have to acquire the data in a way that in the start the motor will come back to home position wherever it was and then I want to move it to the specific position to do the measurements For Example, I want to measure the 40 GHz channel between 1m to 3m movement of a stepper motor on a linear positioning system ball-screw.

  MSI R4670 2D512 D3 GRAPHIC CARD DRIVER DOWNLOAD

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

NI Stepper Motors

Message 4 of moor Motion Control and Motor Drives. Do you have the NI-Motion drivers installed? Message 10 of I am new to labview Message 8 of I have no idea about the programming for this kindso I want your help because I am helpless in this project.

I would also specify what hardware you actually have controller, drive, etc. Message 5 of Message 1 of Please let me know what motion controller you have so that I may give you further assistance.

Is it an NI board? Did you ever get your LV program to work?

Motion Control and Motor Drives

Thanks for your time and concern. Most Active Hardware Boards: Message 2 of This thread is pretty old, so I would recommend making a new thread on our motion control forum so that people in the community reply: Please have a look at this thread.

  MS 7231 MOTHERBOARD DRIVER

There are many different considerations when troubleshooting a motion system, so as much information as you labviea provide would be helpful for us to help you get started!

I see that you have multiple posts regarding the same issue. I need to sync the motion of the stepper motor with my data acquisition. Message 3 of Message 9 of Steve J, Did you ever get a proper response from this posting? Hi Steve, What motion controller are you using? The stepper motors are from LinEngineering and the stepper motor driver is from Peter Norberg Consulting. Message 6 of